This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
tymcom-x-tape [2018/04/13 05:05] jms [Creating the front-end file] Copying the monitor |
tymcom-x-tape [2018/04/24 07:59] jms [Putting TITO.SAV on disk using FILDDT] |
||
---|---|---|---|
Line 189: | Line 189: | ||
15. Boot TYMCOM-X in production mode. Due to Y2K8 problem, must use date from 28 years ago. | 15. Boot TYMCOM-X in production mode. Due to Y2K8 problem, must use date from 28 years ago. | ||
- | (Hit Enter twice to get logged in, then '' | + | (Hit Enter twice r Control-Z L to get logged in, then '' |
| | ||
Line 295: | Line 295: | ||
Exit the TYMCOM-X simh job and start fresh (to get the implied zeroing of memory). | Exit the TYMCOM-X simh job and start fresh (to get the implied zeroing of memory). | ||
+ | ^E | ||
+ | sim>quit | ||
Linux% ./pdp10 x14-prod.ini | Linux% ./pdp10 x14-prod.ini | ||
PDP-10 simulator V4.0-0 Current | PDP-10 simulator V4.0-0 Current | ||
Line 355: | Line 357: | ||
Use '' | Use '' | ||
+ | Success! | ||
==== Other pages ==== | ==== Other pages ==== | ||
[[tymcom-x|Overview]] page, [[tymcom-x-simh|SIMH Setup]] page, [[tymcom-x-startup|TYMCOM-X Startup]] page, [[tymcom-x-tape|TITO on disk]] page, [[tymcom-x-status|Status]] page. | [[tymcom-x|Overview]] page, [[tymcom-x-simh|SIMH Setup]] page, [[tymcom-x-startup|TYMCOM-X Startup]] page, [[tymcom-x-tape|TITO on disk]] page, [[tymcom-x-status|Status]] page. | ||