Differences
This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
|
|
its_using_gt40 [2020/03/16 18:55] lars |
its_using_gt40 [2020/03/16 19:23] (current) lars |
| |
To use the GT40 with ITS, log in with //^Z// and start //GTLOAD// to upload software. There is a Datapoint emulator called VT07. When the GTLOAD prompt "*" appears, type the filename //GT40;VT07// and type enter. The upload will take a long time: one or two minutes. When the terminal emulator starts, it will type out "ITS IN OPERATION" at which point the GT40 can be used much like a Datapoint except it has additional lower case characters. | To use the GT40 with ITS, log in with //^Z// and start //GTLOAD// to upload software. There is a Datapoint emulator called VT07. When the GTLOAD prompt "*" appears, type the filename //GT40;VT07// and type enter. The upload will take a long time: one or two minutes. When the terminal emulator starts, it will type out "ITS IN OPERATION" at which point the GT40 can be used much like a Datapoint except it has additional lower case characters. |
| |
| VT07 can also accept graphics commands. This facility can be used by Lisp and SUDS. |
| |
There is some other GT40 software. To run something else, restart the GT40 (emulator) and run GTLOAD again. | There is some other GT40 software. To run something else, restart the GT40 (emulator) and run GTLOAD again. |