User Tools

Site Tools

You are here: start » its_using_gt40
its_using_gt40

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
its_using_gt40 [2020/03/16 18:55]
lars 		its_using_gt40 [2020/03/16 19:23]
lars
Line 6: Line 6:
  
 To use the GT40 with ITS, log in with //^Z// and start //GTLOAD// to upload software.  There is a Datapoint emulator called VT07.  When the GTLOAD prompt "*" appears, type the filename //GT40;VT07// and type enter.  The upload will take a long time: one or two minutes.  When the terminal emulator starts, it will type out "ITS IN OPERATION" at which point the GT40 can be used much like a Datapoint except it has additional lower case characters. To use the GT40 with ITS, log in with //^Z// and start //GTLOAD// to upload software.  There is a Datapoint emulator called VT07.  When the GTLOAD prompt "*" appears, type the filename //GT40;VT07// and type enter.  The upload will take a long time: one or two minutes.  When the terminal emulator starts, it will type out "ITS IN OPERATION" at which point the GT40 can be used much like a Datapoint except it has additional lower case characters.
 +
 +VT07 can also accept graphics commands.  This facility can be used by Lisp and SUDS.
  
 There is some other GT40 software.  To run something else, restart the GT40 (emulator) and run GTLOAD again. There is some other GT40 software.  To run something else, restart the GT40 (emulator) and run GTLOAD again.
its_using_gt40.txt · Last modified: 2020/03/16 19:23 by lars

Page Tools

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki